Lucid Water Ingress / Seal Failure

Lucid charger leaks water from the bottom of the enclosure or shows signs of internal moisture.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Damaged or improperly seated Lucid enclosure gasket, Conduit entry not sealed, Mounting on a surface that channels water into the unit

How to Fix / Troubleshooting

Safety first: Turn OFF the breaker immediately. Do not operate a charger with water inside.

Steps:

  • External inspection: Look for cracks in the Lucid housing, missing screws, or open knockouts.
  • Drying: Remove the front cover (with power OFF) and gently dry visible moisture with absorbent cloths. Allow the unit to air dry for at least 24 hours in a dry environment.
  • Check gaskets: Inspect the perimeter gasket and any cable/conduit grommets for damage or misalignment.

Resolution: Replace damaged Lucid enclosure gaskets or grommets and reseal conduit entries with appropriate fittings. If corrosion or damage to the control or power board is visible, those assemblies must be replaced.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Lucid Enclosure Gasket / Control Board / Power Module
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements