Charger’s front LEDs are flashing in an unusual pattern not documented in the user guide, but no code is shown in the app.

Safety first: If the charger behaves unpredictably, avoid using it until stable.

• Power‑cycle: Turn off the charger at the isolator for at least 2 minutes, then restore power and observe LED behaviour.
• Check app status: Open the Rolec app to see if any hidden diagnostic messages or warnings are logged.
• Firmware update: If an update is available, apply it following Rolec’s instructions to ensure the latest LED patterns and fault handling are in place.
• Inspect display connections (power off): If the unit has a separate LED/display board, reseat the ribbon cable or connector between it and the main PCB.
• If instability continues: Contact Rolec support with the LED pattern description; the main control PCB or display board may require replacement.