Beko
Thermostat or Temperature Control Failure
Freezer over-freezing, temperature much lower than set, ice forming on packaging
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck thermostat contacts (mechanical models), Faulty NTC sensor reading too warm, Main control board relay stuck on, Incorrect temperature setting
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing controls.
Steps:
- Check settings: Ensure the control is not set to maximum or Super/Quick Freeze mode. Adjust to a mid-range setting.
- Observe compressor: After adjustment, monitor whether the compressor cycles off periodically. Continuous running suggests a control fault.
- Mechanical thermostat models: Access the thermostat behind the control knob. If tapping the thermostat causes the compressor to stop/start erratically, replace the thermostat with a genuine Beko part.
- Electronic models: Replace the freezer NTC sensor first. If over-freezing continues, the main control board may need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Thermostat / Temperature Control
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements