AL
GE Profile
General Alarm Condition
Display shows AL or Alarm and beeps continuously; may accompany HI or LO temperature indications
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
High temperature condition, Low temperature condition, Door left open, Sensor or control board fault
How to Fix / Troubleshooting
Safety first: Avoid silencing alarms without investigating the cause; food safety may be at risk.
- Check the display: Note any additional codes such as HI, LO, or dE that indicate the specific alarm source.
- Verify door status: Ensure the door is fully closed and the gasket is sealing all around. Correct any obstructions.
- Check interior temperature: Use a separate freezer thermometer to confirm actual temperature. If the reading is normal but the alarm persists, a sensor or control issue is likely.
- Silence the alarm: Press the Alarm Reset or Alarm button to silence. If the alarm returns within minutes, further diagnosis is needed.
- Inspect sensors (advanced): On models with accessible thermistors, check for broken wires or sensors encased in ice. Replace any damaged thermistor with a GE-approved part.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements