E8
Gladiator
Display / Sensor Calibration Error
“E8” error code appears; Gladiator freezer may show erratic temperature readings or incorrect display values.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Internal display board fault, Incorrect sensor calibration data, Loose display connector, Control board firmware issue
How to Fix / Troubleshooting
Safety First: Disconnect power before accessing the display or control boards.
- Step 1 – Verify actual temperature: Place an accurate freezer thermometer inside and compare to the displayed temperature after 24 hours. Note any large discrepancy.
- Step 2 – Power reset: Unplug the freezer for 5–10 minutes, then restore power. If E8 returns, continue.
- Step 3 – Inspect display connections: Remove the control housing and check the wiring harness between the display module and the main control board. Reseat connectors.
- Step 4 – Replace display or control: If wiring is intact, replace the display module first. If the issue persists, replace the electronic control board as per Gladiator service documentation.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Display Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements