E8
JennAir
Condenser Fan Motor Error
Display shows E8, condenser fan may not run, compressor runs hot, poor cooling.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed condenser fan motor, Fan blades obstructed by debris, Wiring harness damage near compressor compartment, Defective main control board fan output
How to Fix / Troubleshooting
Safety first: Unplug the freezer before accessing the rear compartment or fan area.
- Step 1 – Access condenser fan: Move the freezer away from the wall and remove the lower rear access panel to expose the condenser fan near the compressor.
- Step 2 – Inspect for debris: Clear any dust, pet hair, or packaging material blocking the fan blades or grille.
- Step 3 – Check fan operation: With power restored briefly, observe whether the fan runs when the compressor is on. If it does not start, unplug again and continue.
- Step 4 – Test fan motor: Spin the blades by hand; they should rotate freely. If stiff or seized, the motor is likely bad and should be replaced.
- Step 5 – Replace fan motor: Install a JennAir-compatible condenser fan motor, reconnect wiring, and ensure the blades are not rubbing on any shrouds.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Condenser Fan Motor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements