H91
Panasonic
Non-Volatile Memory / Power Failure Detection Fault
H91 error, power failure alarm or memory error after outage
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM on main PCB, unstable mains power, failing backup capacitor on PCB, firmware error
How to Fix / Troubleshooting
Safety: Disconnect power before accessing the control board.
Steps:
- 1. Power cycle: Unplug the freezer for at least 10 minutes to allow capacitors to discharge, then reconnect.
- 2. Check outlet: Verify the wall outlet is properly grounded and not shared with heavy-load appliances that cause voltage dips.
- 3. Surge protection: Consider using a surge protector or voltage stabilizer suitable for refrigerators/freezers.
- 4. If H91 persists: The main control PCB's memory or firmware may be corrupted. Replacement of the PCB is typically required and may need configuration by a Panasonic technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements