E10
CAME
Service Interval or Excessive Cycle Count Lockout
Display shows E10, door will not move, service LED may flash rapidly
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Service counter exceeded on CAME control unit, Maintenance reminder not reset, Parameter misconfiguration causing lockout
How to Fix / Troubleshooting
Safety first: Before resetting any service lockout, ensure the door and operator are mechanically safe.
Steps:
- Inspect mechanical components: Check springs, cables, rollers, and the CAME drive for wear or damage. Lubricate moving parts as recommended.
- Access service menu: Enter the installer or service menu on the CAME control board (refer to manual). Locate the service counter or maintenance parameter.
- Reset service counter: Follow the documented procedure to reset or extend the service interval.
- Test operation: Run a full open/close cycle and verify smooth movement without unusual noises.
If you cannot access the installer menu or the code reappears, contact a CAME service technician to perform a full maintenance and reset.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements