Garage door opens and closes normally from wall button but does not respond to any CAME remote controls

Safety first: Keep clear of the door while testing remotes.

Steps:

• Replace batteries: Fit new, correct‑type batteries in each CAME remote (observe polarity). Test again.
• Reprogram remotes: Enter learning mode on the CAME receiver (button on AF card or control board) and store each remote following the manual.
• Check antenna: Ensure the antenna wire is connected and not cut. For external antennas, check the coax connector.
• Test receiver: If possible, try a known‑working CAME remote. If none work, the receiver card may be faulty and should be replaced.

Consider interference sources (LED lights, Wi‑Fi routers) near the opener that can reduce radio range; relocate if necessary.