E6
FAAC
Motor Overload or Overcurrent Fault
Opener runs briefly then stops with E6; motor hums or struggles; may trip thermal protection.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Seized FAAC motor gearbox, Shorted motor windings, Door excessively heavy or unbalanced, Incorrect motor type configured on control board
How to Fix / Troubleshooting
Safety: Disconnect power. Release the door using the emergency release and secure it so it cannot fall.
- Check door movement: Move the door by hand. If it is difficult to move or falls rapidly, call a door specialist to adjust springs and hardware before using the opener again.
- Inspect motor and gearbox: With the door disconnected, run the FAAC opener briefly. If the motor still struggles or E6 appears, the motor or gearbox may be seized.
- Check configuration: On programmable FAAC units, verify that the correct motor type and power rating are selected in the control menu or DIP switches.
- Allow cooling time: If the opener has been used heavily, allow 20–30 minutes for the thermal protector to reset, then test again with the door disconnected.
- Replace motor assembly if needed: If the motor hums without turning or trips E6 immediately with no load, the FAAC motor/gearbox assembly is likely defective and should be replaced as a unit.
Do not continue to run a stalled motor; this can cause permanent damage and potential fire risk.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
FAAC Motor and Gearbox Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements