Gliderol opener shows E14; door opens but will not close from remote, yet will close when the wall button is held down continuously.

Safety first: Never permanently bypass safety devices. Any changes must maintain compliance with local safety standards.

Steps to resolve constant pressure close mode:

• 1. Check safety beams: Ensure Gliderol safety beams are installed, aligned, and wired correctly. Replace damaged units.
• 2. Inspect safety input jumpers: Some Gliderol boards use jumpers to select safety device type. Verify jumper positions match the installation manual.
• 3. Test safety edge (if fitted): If a monitored safety edge is connected, check its cable and switch for continuity. Bypass only temporarily for testing as per manual.
• 4. Reset logic: Power cycle the opener and, if available, restore factory defaults for safety inputs, then reconfigure according to the door type.

If E14 persists with correctly wired and functioning safety devices, the safety input circuitry on the control board may be defective and require board replacement.