Gliderol
Open Circuit Wall Control Wiring
Gliderol garage door opener operates from remote but not from wall button or key switch.
Advertisements
Possible Causes
Broken low-voltage cable to wall button, Faulty wall switch contacts, Loose terminals at control board, Water ingress into wall station
How to Fix / Troubleshooting
Safety first: Turn off power before working on wiring.
Steps to fix wall control:
- 1. Inspect wall station: Remove and check for corrosion or broken wires. Replace if damaged.
- 2. Test at opener: Short the wall control terminals at the Gliderol board. If the door runs, the wiring or switch is faulty.
- 3. Replace cable: Run a new two‑core low‑voltage cable if continuity is lost.
Advertisements
Repair Difficulty
Easy
2/5
Required Part
Gliderol Wall Control Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements