Gliderol Close Limit Overshoot / Floor Obstruction Detection

Gliderol garage door will not stay closed; it reaches the floor then immediately opens again.

Advertisements

Possible Causes

Close limit set too far, Door hitting raised floor or new seal, Safety beam misalignment at floor level, Excessive down force causing bounce

How to Fix / Troubleshooting

Safety first: Keep clear of the door while adjusting limits.

Steps to keep door closed:

  • 1. Inspect floor area: Check for new rubber seals, mats, or raised concrete that may stop the door early.
  • 2. Adjust close limit: Move the close limit cam or reprogram the electronic close limit so the door stops just as it contacts the floor.
  • 3. Check beams: Ensure safety beams are not being blocked by objects near the floor.
Advertisements

Repair Difficulty

Easy 2/5

Required Part

Gliderol Limit Switch Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements