Disposal will not start, but a faint click is heard from the unit when the switch is turned on.

Safety First: Turn OFF power at the breaker before removing any covers.

• Step 1 – Verify lid or stopper (batch-feed models): Ensure the batch-feed stopper or magnetic lid is fully seated and oriented correctly to engage the safety interlock.
• Step 2 – Inspect internal wiring: Remove the bottom cover and check for loose spade connectors or wire nuts between the power input and motor.
• Step 3 – Check control module: On models with a separate control module, look for burn marks or swollen components. Replace the control module if available as a service part.
• Step 4 – Test: Restore power and test. If the click persists without motor operation and wiring is intact, the internal relay or motor is likely defective.
• In most cases, replacement of the entire disposal is more practical than control or motor repair.