Electrolux
Improper Initial Installation / Mounting Misalignment
Newly installed Electrolux disposal vibrates and leaks slightly at the sink flange immediately after installation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Mounting ring not fully locked, Uneven tightening of mounting screws, Insufficient plumber's putty, Misaligned sink flange
How to Fix / Troubleshooting
Safety First: Turn OFF power at the breaker and disconnect the power cord before adjusting the mounting.
- Step 1 – Check mounting ring engagement: From below, rotate the mounting ring clockwise until all three mounting tabs are fully locked into place.
- Step 2 – Verify sink flange seating: If the flange appears tilted or there is a gap, remove the disposal and reseat the flange with fresh plumber's putty.
- Step 3 – Tighten evenly: Tighten the mounting screws or ring evenly around the flange to ensure a uniform seal.
- Step 4 – Test for leaks and vibration: Reinstall the disposal, reconnect plumbing and power, then run water and operate the unit while checking for leaks and excessive movement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Mounting Assembly Kit
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements