Garbage disposal works, but there is a constant low-level water drip from the discharge pipe joints.

Safety first: Turn off the disposal and avoid using the sink until leaks are addressed.

• Tighten slip nuts: Hand-tighten, then slightly wrench-tighten the slip nuts on the P-trap, cross tube, and tailpiece connected to the Reginox discharge.
• Inspect washers: Disassemble leaking joints and inspect the conical washers. Replace any that are flattened, cracked, or missing.
• Align piping: Adjust pipe lengths and supports so that joints are not under stress or misaligned.
• Test for leaks: Run water and observe all joints. Re-tighten as needed.