Jet pump runs but jets are weak or no water comes out

Safety first: Turn off power at the GFCI breaker before loosening any unions.

Weak or no jets with the pump running usually indicates an air lock or blockage.

• Check water level: Ensure the spa is filled to the proper level above all jets and suctions.
• Open all jets: Turn each jet face counterclockwise to the fully open position.
• Bleed air from pump: Loosen the union on the suction side of the jet pump until air and then water escapes, then retighten.
• Clean filter: Remove and rinse the American Whirlpool filter cartridge; try running briefly without the filter to test jet strength.
• Inspect pump impeller: If flow is still weak, remove the pump wet end and check for debris wrapped around the impeller.

Persistent weak jets may indicate a worn impeller or failing pump motor that should be replaced.