Display shows P2 ERR or Pump 2 error, secondary jet zone does not operate.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed Pump 2 motor, Tripped internal thermal overload in Pump 2, Loose Pump 2 connector at control pack, Overloaded circuit due to incorrect wiring

Safety: Turn off power at the GFCI.

Cool-down: If Pump 2 stopped after extended use, allow it to cool for 30–60 minutes and try again. Internal overloads can reset.
Check valves: Ensure slice valves on Pump 2 suction and return lines are fully open.
Inspect connector: Confirm Pump 2 is plugged into the correct socket on the control pack and that there is no visible damage.

Persistent P2 errors usually indicate a failing pump motor or control board relay and should be serviced by a technician.

Hard 4/5

Pump 2 (jet pump) assembly

Check Price on Amazon

We may earn a commission from links on this page.