P2
Bullfrog Spas
Pump 2 Drive or Overcurrent Fault
Display shows P2 error; Pump 2 does not operate correctly
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Seized Pump 2 motor, Shorted Pump 2 cable, Incorrect pump size installed, Failed Pump 2 relay on control board
How to Fix / Troubleshooting
Safety: Turn OFF power at the GFCI breaker before servicing Pump 2.
- Check Pump 2 connection: Verify that Pump 2 is plugged into the correct receptacle on the control pack and that the connector is not burned or loose.
- Inspect for leaks: Look for water leaks around Pump 2 that may have entered the motor or wiring compartment.
- Spin test: With power OFF, attempt to rotate the motor shaft by hand. If it is stiff or frozen, the pump is likely seized and must be replaced.
- Measure winding resistance: Use a multimeter to check for proper resistance across the motor leads. A short or open indicates motor failure.
- Replace Pump 2 if faulty: Install a Bullfrog-approved replacement pump matching the original specifications.
If P2 persists with a good pump, the control board's Pump 2 circuit may be damaged; professional replacement of the control pack is recommended.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Pump 2 Jet Pump Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements