P2
Canadian Spa Company
Pump 2 drive or overload fault
Display shows P2 error and Pump 2 does not operate.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Seized Pump 2 motor, Loose or burnt wiring, Failed pump relay, Incorrect voltage configuration
How to Fix / Troubleshooting
Safety: Disconnect power at the GFCI before inspection.
- Inspect Pump 2: Check for leaks, burnt odor, or visible damage.
- Verify wiring: Ensure Pump 2 is wired according to Canadian Spa Company wiring diagram (correct voltage and terminal positions).
- Check for obstructions: Confirm that suction and return lines for Pump 2 are not blocked.
- Test briefly: Restore power and attempt to start Pump 2. If it trips the breaker or hums without turning, the motor is likely faulty.
Replace Pump 2 if the motor is defective. If a new pump still triggers P2, the spa pack may have a defective relay or drive circuit.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Pump 2 (Jet Pump) for Canadian Spa Company Spa
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements