P2
Clearwater Spas
Pump 2 Overcurrent or Fault
Display shows P2 error, second jet pump fails to start or trips breaker.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Seized Pump 2 motor, Shorted windings in Pump 2, Incorrect voltage configuration, Control board relay failure
How to Fix / Troubleshooting
Safety first: Shut off power at the GFCI breaker before inspecting Pump 2.
- Check configuration: Confirm that the Clearwater Spas is wired for the correct voltage (120/240V) as per the pump and control pack rating.
- Inspect Pump 2: Look for signs of overheating, burnt smell, or water leaks around the pump.
- Manual rotation: Attempt to rotate the motor shaft by hand. If stiff or locked, the pump may need replacement.
Pump overcurrent faults generally require a technician to test motor windings and control board outputs.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements