Evolution Spas Pump 2 Control or Relay Fault

Display shows U2, pump 2 does not operate or behaves erratically.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed pump 2 motor, Loose wiring to pump 2, Stuck pump 2 relay on control board, Incorrect configuration for second pump

Safety: Shut off power at the GFCI breaker before working on pump wiring.

Verify wiring: Confirm pump 2 is wired to the correct terminals and that all connections are tight.
Check pump operation: If qualified, bench-test pump 2 with proper voltage to see if it runs.
Inspect control board: Look for damage near the pump 2 relay.

If pump 2 is good but does not run from the control pack, the control board likely needs replacement by a technician.

Hard 4/5

Pump 2 (Jet Pump)

Check Price on Amazon

We may earn a commission from links on this page.