COdE
LA Spas
Control System Configuration / Programming Mode
Display shows CODE or similar, spa may be in programming or diagnostic mode and not heat.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect dip switch settings on control board, Control pack replaced and not configured, User accidentally entered programming mode
How to Fix / Troubleshooting
Safety: Turn off power before adjusting any dip switches or jumpers.
- Consult wiring diagram: Inside the control box cover, locate the LA Spas configuration chart. Verify that dip switches and jumpers match your spa's equipment (number of pumps, voltage, etc.).
- Exit programming mode: If the topside is in a setup menu, follow the manual to exit and return to normal operation.
- Power cycle: After correcting settings, turn power off for 30 seconds and back on to reload configuration.
If CODE persists, the control board firmware may be incompatible with your topside and should be evaluated by a spa technician.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements