COdE
RivieraPool
Control System Configuration / Programming Mode
Display shows COdE or CODE and spa is unresponsive to normal controls.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Control pack in programming mode, Corrupted configuration, Incorrect DIP switch or jumper settings on control board
How to Fix / Troubleshooting
Safety: Disconnect power before changing any DIP switches or jumpers.
- Power reset: Turn off power for 1–2 minutes, then restore. If COdE remains, the control is likely in a configuration state.
- Consult RivieraPool manual: Refer to your specific RivieraPool spa model manual for the correct DIP switch and jumper settings for voltage, pump configuration, and heater size.
- Verify settings: Open the control pack and compare DIP switch positions to the manual. Correct any mismatches.
- Factory reset (if available): Some RivieraPool controls allow a factory reset sequence via the keypad. Follow the documented steps to restore default settings.
- Board replacement: If COdE persists and settings are correct, the RivieraPool control board may be corrupted and require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
RivieraPool control board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements