P2
RivieraPool
Pump 2 Circuit Fault
Display shows P2 ERR or P2 and pump 2 does not operate correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed pump 2 motor, Loose or reversed wiring, Incorrect pump size for control pack, Faulty pump 2 relay on control board
How to Fix / Troubleshooting
Safety: Disconnect power before servicing pump 2.
- Verify wiring: Confirm that the RivieraPool pump 2 is wired according to the control pack diagram (correct voltage and terminal positions).
- Check motor: Attempt to spin the pump 2 shaft by hand with power OFF. If stiff or seized, the pump is likely bad.
- Load check: If the breaker trips when pump 2 starts, the motor may be shorted or drawing excessive current.
- Replace as needed: Install a new RivieraPool pump 2 assembly if the motor is defective. If the pump is good but never energizes, the control board pump 2 relay may require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
RivieraPool pump 2 assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements