Sunrise Spas Topside Display Failure

Topside control panel display is blank but spa components run

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed topside control panel, Loose ribbon cable connection, Moisture damage to keypad, Control pack low-voltage output issue

Safety first: Turn off power before disconnecting the topside panel.

Check cable connection: Remove the control pack cover and verify that the topside ribbon cable is fully seated in its connector.
Inspect cable: Look for cuts or pinch points along the cable path.
Dry panel: If condensation is visible under the panel overlay, allow it to dry fully.
Replace panel: If still blank, replace the Sunrise Spas topside control panel with the correct model.

Medium 3/5

Topside Control Panel

Check Price on Amazon

We may earn a commission from links on this page.