F3
Bionaire
Ultrasonic Transducer / Nebulizer Fault
Humidifier displays F3 and fan may still run without mist
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed ultrasonic transducer disc, Mineral scaling on transducer surface, Open or shorted transducer driver circuit, Loose wiring to transducer
How to Fix / Troubleshooting
Safety: Unplug the humidifier and empty the tank. Never touch the transducer while the unit is powered.
Steps:
- Access transducer: Remove the water tank and any covers over the base to expose the ultrasonic transducer (metal disc in the water well).
- Descale: Gently clean the transducer surface with a cotton swab dipped in white vinegar, then wipe with clean water. Do not scratch the disc.
- Inspect wiring: Check the wires from the control board to the transducer for damage or loose connectors. Reseat connectors.
- Test operation: Reassemble, refill, and power on. If F3 persists and no mist is produced, the transducer or its driver circuit is likely defective.
- Replace transducer module: Install a new Bionaire ultrasonic transducer assembly. If the error remains, replace the main control PCB that drives the transducer.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Ultrasonic Transducer Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements