E3
Crane
Humidity Sensor Fault (Dehumidifier)
Crane dehumidifier displays E3 and the fan may run but compressor does not engage.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed internal humidity sensor, Disconnected sensor harness, Sensor blocked by dust, Corroded sensor contacts
How to Fix / Troubleshooting
Safety first: Unplug the dehumidifier before opening the cabinet.
- 1. Locate humidity sensor:
- Often mounted behind the front grille or on the control panel board.
- 2. Clean sensor area:
- Use a soft brush to remove dust from the sensor and surrounding vents.
- 3. Check connections:
- Ensure the sensor plug is firmly connected to the control PCB.
- 4. Replace sensor:
- If E3 persists, replace the humidity sensor module with a Crane-compatible part.
- 5. Control board evaluation:
- If a new sensor does not resolve E3, the control board may need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Humidity Sensor Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements