F0
De'Longhi General Sensor Fault / EEPROM Error (Model-Dependent)

De'Longhi dehumidifier shows F0 and will not start normal operation.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted control board memory, Multiple sensor inputs out of range, Loose board connectors, Failed main control PCB

How to Fix / Troubleshooting

Safety first: Unplug the unit before opening any covers.

Step-by-step:

  • 1. Hard reset: Unplug the dehumidifier for at least 10 minutes to allow capacitors to discharge. Plug back in and test.
  • 2. Inspect all sensor connections: Access the main PCB and check that all sensor harnesses (temperature, humidity, defrost) are firmly connected.
  • 3. Look for board damage: Examine the PCB for burn marks, corrosion, or swollen components. If present, the board should be replaced.
  • 4. Firmware/EEPROM issues: Some models may require board replacement if internal memory is corrupted. This is not field-repairable.
  • 5. Contact service: If F0 persists after reseating connectors, arrange for an authorized De'Longhi technician to replace the control board.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control PCB
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements