Devola dehumidifier shows E5 and stops; compressor does not run.

Safety: Unplug the unit before inspection. Do not bypass any safety devices.

E5 is commonly associated with compressor protection or high-temperature faults.

• Ventilation check: Ensure the unit is placed with adequate clearance on all sides and not in a confined space. Overheating can trigger E5.
• Clean condenser area: Remove the rear or side panel to access the condenser coil (the warm coil near the compressor). Use a soft brush or vacuum to remove dust and lint from the fins.
• Check the fan: Confirm that the condenser fan runs when the unit attempts to start the compressor. If the fan is not spinning or is noisy/stiff, the condenser fan motor may be failing and should be replaced.
• Allow cool-down: If the compressor is very hot to the touch (do not burn yourself), allow the unit to cool for at least 1 hour before retrying.
• Inspect wiring to compressor: With power disconnected, check the wiring harness and connectors at the compressor and overload protector for signs of burning or loose connections.
• Replace faulty components: If the fan motor is seized or the overload protector is visibly damaged, replace with the correct Devola condenser fan motor or compressor overload protector.
• Ongoing E5: If E5 persists, the compressor itself or the main control PCB may be defective. This is a complex repair requiring a refrigeration technician.