E9
Orbegozo
Internal Memory or EEPROM Error
Dehumidifier displays E9 and will not run
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM on main PCB, Voltage spike damage, Failed main control board microcontroller
How to Fix / Troubleshooting
Safety: Disconnect from mains before opening the unit.
Steps:
- Power reset: Unplug for 15 minutes to fully discharge internal circuits, then reconnect.
- Check power quality: Avoid using unstable power sources or undersized generators. Use a surge protector if your mains supply is prone to spikes.
- Inspect main PCB: Remove the control cover and visually inspect the main board for burn marks, swollen components, or corrosion.
- Firmware reset (if available): Some Orbegozo models may support a factory reset via key combination (consult the user manual). Try this if documented.
- Replace main PCB: If E9 persists and there is no reset procedure, the EEPROM or microcontroller is likely damaged. Replace the main control board with an Orbegozo original part.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements