H3
Orbegozo
Overheat Protection / Temperature Sensor Fault in Humidifier Base
Humidifier displays H3 and shuts down shortly after starting
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked air vents under base, Failed base NTC sensor, Shorted heater element (for warm mist models), Faulty thermal fuse
How to Fix / Troubleshooting
Safety: Unplug the humidifier and allow it to cool completely before opening.
Steps:
- Check ventilation: Ensure the base vents are not blocked by carpets or objects. Place the unit on a hard, flat surface.
- Clean air paths: Remove dust from intake and exhaust openings.
- Inspect base sensor: Open the base to locate the NTC sensor near the heater or power components. Check wiring and connector.
- Replace NTC or thermal fuse: If the sensor is open/shorted or the thermal fuse is blown, replace with the correct Orbegozo parts.
- Heater check (warm mist): For warm mist models, inspect the heater element for scale buildup and clean according to the manual. Severe scaling can cause overheating.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Base NTC Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements