E5
Vicks
Ultrasonic Transducer / Nebulizer Error
Display shows “E5” and there is no mist output from an ultrasonic Vicks humidifier.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed ultrasonic transducer disc, Loose transducer wiring, Mineral scale on transducer surface, Faulty driver circuit on PCB
How to Fix / Troubleshooting
Safety first: Turn OFF, unplug, and empty the water tank before working near the transducer.
- Clean transducer: Locate the round metal ultrasonic transducer in the base water reservoir. Soak a cotton swab in white vinegar and gently clean the surface to remove mineral deposits. Do not scratch the disc.
- Rinse and dry: Rinse the base with clean water and dry the transducer area with a soft cloth.
- Check wiring: If you can access the underside of the base, verify that the transducer’s two-wire connector is firmly attached to the PCB.
- Replace transducer: If E5 persists and there is still no mist, the transducer module or its driver circuit is likely defective and should be replaced as an assembly.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Ultrasonic Transducer Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements