E03
Adler
High-Pressure Refrigeration System Fault
Display shows E03 and the unit shuts down; compressor does not start or stops quickly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked condenser coil on Adler ice maker, Failed or slow Adler condenser fan motor, Refrigerant overcharge or restriction, Ambient temperature too high around unit
How to Fix / Troubleshooting
Safety first: Unplug the ice maker. Do not attempt sealed-system refrigerant work unless you are a certified technician.
- Clean condenser coil: Remove the lower front or rear grille to access the Adler condenser coil. Use a soft brush and vacuum to remove dust and lint from the fins.
- Check condenser fan: Spin the Adler condenser fan blade by hand (with power off). It should move freely. If stiff or noisy, the fan motor may be failing.
- Verify fan operation: Restore power briefly and observe if the fan runs when the compressor is commanded on. If the compressor runs but the fan does not, replace the Adler condenser fan motor.
- Improve ventilation: Ensure the unit has the clearance specified in the Adler installation manual and is not installed in a confined, overheated space.
- Call a technician if E03 persists: If cleaning and fan replacement do not resolve the error, a sealed-system issue (restriction or charge problem) may exist and requires professional service.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Adler Condenser Fan Motor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements