Avanti
Stuck in Cleaning Mode / Control Panel Fault
Avanti ice maker runs a cleaning cycle repeatedly or will not exit cleaning mode.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck or shorted clean button, control board firmware glitch, keypad membrane failure, water level sensor not detecting end of clean cycle
How to Fix / Troubleshooting
Safety: Unplug before removing the control panel.
Steps:
- 1. Attempt manual exit: Follow the user manual procedure to exit cleaning mode (usually pressing and holding a specific button).
- 2. Power reset: Unplug for 10 minutes, then plug back in and see if the unit returns to normal mode.
- 3. Inspect keypad: Remove the control panel and check for moisture or corrosion on the keypad connector. Dry and reseat.
- 4. Test buttons: Press each button and feel for proper click. If the clean button feels stuck or always registers, the keypad assembly may need replacement.
- 5. Replace control board: If the issue persists, replace the main control board or user interface board as specified for your Avanti model.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Control Panel Keypad
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements