Avanti ice maker's compressor runs continuously and does not cycle off; ice may be too hard or frost builds up.

Safety: Unplug before accessing sensors or control board.

Steps:

• 1. Check door seal: Inspect the gasket for gaps or tears. Replace if not sealing properly.
• 2. Verify ambient temperature: Ensure the room is within the recommended range and away from direct sunlight or heat sources.
• 3. Inspect thermistor: Check that the evaporator or bin thermistor is properly attached and not covered in ice or debris. Replace if readings are out of spec.
• 4. Control board: If sensors and seals are good but the compressor never cycles off, the control board may be stuck in a freeze command and should be replaced.