E08 displayed; ice bin is empty even though the unit appears to run; no water reaches the evaporator tray.

Safety first: Disconnect power and close the water supply.

• Locate level sensor: On many Balay ice makers, a water level probe or float is installed in the reservoir or sump.
• Clean sensor: Remove mineral scale from the probe or float using a soft brush and a food-safe descaling solution. Rinse thoroughly with clean water.
• Check movement: If a float is used, ensure it moves freely up and down without sticking.
• Inspect wiring: Verify that the sensor harness is intact and firmly connected to the control PCB.
• Replace sensor: If cleaning does not resolve the issue and the sensor tests open/shorted with a multimeter, replace the water level sensor assembly.