E09
Balay
Compressor Start Circuit / Overload Protection Fault
E09 error; compressor does not start, or starts briefly then shuts off; no cooling.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective compressor start relay, Failed PTC starter, Open overload protector, Locked compressor
How to Fix / Troubleshooting
Safety first: Unplug the ice maker before accessing the compressor compartment.
- Access compressor: Remove the rear lower service panel to expose the Balay compressor and start components.
- Inspect start relay and overload: Remove the plastic cover on the compressor terminals. Check the PTC relay and overload protector for burn marks, rattling pieces, or melted plastic.
- Test components: Use a multimeter to check continuity of the overload and resistance of the PTC relay. Replace the start relay/overload kit if defective.
- Compressor check: Measure resistance between compressor terminals (C-R, C-S, R-S) and to ground. If windings are open, shorted, or grounded, the compressor is faulty and requires professional replacement.
Refrigerant and compressor work should be performed only by certified refrigeration technicians.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Compressor Start Relay and Overload
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements