Beko ice maker powers on but does not make any ice at all

Safety first: Unplug the unit before removing covers. Turn off water supply if disconnecting hoses.

• 1. Confirm basic conditions:
  • Ensure the unit is switched on and not in a cleaning or standby mode.
  • Verify the ice bin is correctly installed and not signaling 'bin full'.
• 2. Check water supply:
  • Confirm the water shutoff valve is open and the hose is not kinked.
  • Follow the E01/E12 steps to verify water flow.
• 3. Check cooling:
  • After 20–30 minutes of operation, feel inside the ice-making area; it should be getting cold.
  • If not, inspect the compressor and condenser fan as in E05/E06.
• 4. Run a test cycle (if available):
  • Use the control panel to start a manual ice-making or diagnostic cycle.
  • Listen for water filling and the compressor starting.
• 5. Inspect ice maker module:
  • Remove the internal cover and check the ice tray and ejector mechanism for damage.
  • If the module is not moving through cycles, it may need replacement.
• 6. Sensor and PCB check:
  • If water and cooling are present but no ice is produced, the thermistor or main PCB may be mis-controlling the cycle; professional diagnosis is recommended.