Beko ice maker shows E11 and water continuously flows into the ice tray or reservoir

Safety first: Immediately turn off the water supply and unplug the ice maker to prevent flooding.

• 1. Stop water flow:
  • Close the shutoff valve feeding the ice maker.
  • Remove excess water from the bin or reservoir with towels or a wet/dry vacuum.
• 2. Inspect water inlet valve:
  • Remove the rear panel to access the water inlet valve.
  • Disconnect the water line and check for debris at the valve inlet screen.
  • Clean the screen thoroughly.
• 3. Check valve operation:
  • With water off and power disconnected, remove the valve and inspect for internal scale or damage.
  • If the valve does not close fully when de-energized, replace it.
• 4. Verify water level sensor:
  • Follow the E03 procedure to ensure the level sensor is clean and functioning.
• 5. Electrical diagnosis (advanced):
  • Use a multimeter to confirm the valve coil is not shorted.
  • If the control board is sending voltage to the valve when it should be off, the PCB may be faulty.
• 6. Replace components as needed:
  • Install a new Beko water inlet valve and/or water level sensor if defective.
• 7. Restore service:
  • Turn water back on, check for leaks, reconnect power, and clear E11 via the control panel.