E9 error displayed; unit may start then quickly stop with beeping.

Safety first: Turn off and unplug the ice maker. Allow it to cool for at least 30 minutes before further inspection.

• Improve ventilation: Ensure the ice maker is placed in a well‑ventilated area, away from direct sunlight, ovens, or radiators. Maintain at least 10–15 cm clearance on all sides and the back.
• Clean condenser and fan: Remove the rear cover and gently vacuum dust from the condenser coil and fan blades. Use a soft brush to avoid bending fins.
• Check fan operation: Plug the unit back in and briefly start a cycle while observing the fan (keep fingers clear). If the fan does not spin or is noisy, replace the condenser fan motor.
• Ambient temperature: Verify that the room temperature is within the specified range in the Clatronic manual (typically 10–32 °C). Move the unit if necessary.
• PCB thermal sensor: Some models have a thermal sensor on the PCB or compressor. Ensure it is properly attached and not covered with dust. If damaged, replace the sensor or PCB.