Danby ice maker makes ice very slowly; production is much lower than normal.

Safety first: Unplug the ice maker before cleaning coils or fan.

Steps to improve ice production:

• Improve ventilation: Ensure there is adequate clearance around the sides and back of the Danby ice maker as specified in the manual. Do not enclose it in a tight cabinet.
• Clean condenser coils: Remove the rear or bottom panel and use a soft brush and vacuum to remove dust and lint from the condenser.
• Check condenser fan: Make sure the fan spins freely and is not obstructed by debris. Clean the blades and housing.
• Lower ambient temperature: Move the unit away from heat sources (ovens, direct sunlight) and operate it in a cooler room if possible.
• Descale the water system: Mineral buildup can reduce heat transfer. Run a cleaning cycle with a manufacturer‑approved descaling solution or a 1:1 vinegar and water mix, then rinse thoroughly.

If performance does not improve after these steps, a weak compressor or sealed system issue may be present and requires professional service.