Danby ice maker shows E9; unit powers on but compressor and fan do not start.

Safety first: Unplug the ice maker before inspecting electrical components. Do not bypass fuses or safety devices.

Steps to address E9:

• Verify outlet power: Plug another appliance or a lamp into the same outlet to confirm proper voltage. Avoid using long or undersized extension cords.
• Inspect the power cord: Check the Danby power cord for cuts, kinks, or burn marks. Ensure it is fully inserted into the outlet.
• Access the control board: Remove the rear or side panel to reach the main PCB. Look for an onboard fuse or line filter. If a glass fuse is present, inspect it visually and test continuity with a multimeter.
• Check for burnt components: Examine the board for darkened areas, bulging capacitors, or burnt smells. These indicate a failed power supply section.
• Replace blown fuse (if user‑serviceable): If the fuse is blown and there is no obvious short, replace it with the exact same type and rating. If it blows again immediately, stop and seek professional service.
• Replace the control board: If the power supply section is damaged, replace the main control PCB with a Danby‑approved part. Transfer all connectors carefully.

Warning: Working on live high‑voltage circuits is dangerous. If you are not experienced with electrical repairs, contact a qualified technician.