F10
Fisher & Paykel
Ice Maker Communication / Control Fault
F10 displayed, no ice production and the main display may show a general ice maker fault icon.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed ice maker control module, communication error between ice module and main PCB, damaged data harness, corrosion at connector pins
How to Fix / Troubleshooting
Safety first: Disconnect power before unplugging or plugging any control connectors.
- Step 1 – Reseat connectors: Access the ice maker module and main control board (usually at the rear or top of the cabinet). Carefully unplug and replug the ice maker harness connectors to clear oxidation.
- Step 2 – Inspect harness: Follow the harness path between the ice maker and main board. Look for crushed, cut, or chewed wires, especially where the harness passes through cabinet openings.
- Step 3 – Check for moisture: Ensure there is no condensation or water intrusion at the connectors. Dry gently if needed.
- Step 4 – Module replacement: If wiring is intact and F10 persists, replace the Fisher & Paykel ice maker module/control assembly.
If the error remains after module replacement, the main control board may be defective and should be replaced or tested by a qualified technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Ice Maker Control Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements