Galanz Runaway Cooling / Control Feedback Failure

Ice maker runs continuously without cycling off, even when little or no ice is produced.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Faulty evaporator or ambient temperature sensor, Ice full sensor not detecting bin level, Stuck relay on main control board, Control board firmware fault

How to Fix / Troubleshooting

Safety first: Unplug the unit if it runs excessively hot or for many hours without stopping.

Steps to troubleshoot:

  • Check sensors: Inspect and clean the evaporator temperature sensor, ambient sensor, and ice full sensor. Ensure they are properly mounted.
  • Observe operation: After restarting, monitor whether the unit ever enters a harvest or standby mode.
  • Replace suspect sensors: If readings are clearly wrong (e.g., unit thinks it is always warm), replace the affected sensor.
  • Control board: If sensors are good but the unit never cycles off, the main control board relay or logic may be stuck and should be replaced.
Advertisements

Repair Difficulty

Hard 4/5

Required Part

Main Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements