E13
Hotpoint
Overcurrent or Short Circuit Protection
Ice maker shows E13 and may shut down shortly after startup.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted compressor windings, Shorted fan motor, Damaged wiring harness causing a short to chassis
How to Fix / Troubleshooting
Safety: Unplug the unit immediately if you suspect a short. Do not reset breakers repeatedly.
- Visual inspection: Remove rear panel and inspect wiring for burn marks, melted insulation, or loose connectors touching metal.
- Check motors: Smell for burnt odor near the compressor and fan motors. A strong burnt smell often indicates internal motor failure.
- Isolate components (advanced): With a meter, check resistance of compressor and fan windings to ground. Any continuity to ground indicates a shorted component that must be replaced.
- Repair wiring: Replace any damaged harness sections with proper gauge wire and insulated connectors.
Because E13 involves electrical safety, if you are not experienced with electrical testing, contact a professional technician to locate and replace the shorted component.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements