Iceman General No-Ice Production Fault

Ice maker runs but produces no ice at all (no error code displayed)

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Water supply turned off, Clogged water inlet valve screen, Failed circulation pump, Severely dirty evaporator or scale buildup

How to Fix / Troubleshooting

Safety: Unplug the Iceman ice maker and shut off water before internal inspection.

  • 1. Confirm basics: Ensure the unit is switched to ICE mode, not CLEAN or STANDBY. Verify the ice bin is properly installed and not triggering a bin-full sensor.
  • 2. Check water supply: Confirm the external shutoff valve is open and the supply line is not kinked. Disconnect at the unit and verify strong flow into a bucket.
  • 3. Inspect water system: Remove panels and check the inlet valve screen, reservoir, and circulation pump for blockages. Clean and descale as needed.
  • 4. Observe operation: With panels temporarily off and power restored, watch a cycle: verify the compressor, fan, and pump all run, and that water flows over the evaporator. If any component is not operating, troubleshoot that specific part (pump, fan, compressor start components).
  • 5. Descale evaporator: Heavy mineral buildup can prevent proper heat transfer. Run a full cleaning/descaling cycle with Iceman-approved cleaner, following the manual exactly, then test ice production again.
Advertisements

Repair Difficulty

Medium 3/5
Advertisements