Safety first: Disconnect power before removing interior panels.

Check door/bin seal: Inspect the ice bin door gasket for tears, warping, or debris preventing a tight seal. Clean the gasket and mating surfaces with warm soapy water. Replace the gasket if damaged.
Verify internal fan operation: Many Ikea ice makers use a small fan to circulate cold air around the bin. Remove the interior panel to access the fan. Spin the blade by hand and check for obstructions. If the fan does not run when the compressor is on, test and replace the fan motor.
Inspect insulation panels: Ensure interior panels are properly seated and not leaving gaps where warm air can enter.
Control board check: If fans and seals are good but temperature remains high, the control board may not be cycling the compressor correctly. Inspect for damage and replace if necessary.
Allow cool-down: After repairs, let the unit run for several hours and monitor bin temperature and ice condition.

E11 displayed, internal temperature too high, ice melts quickly in bin

Possible Causes