Klarstein
Ice Level Detection Failure (No Auto-Stop)
Ice maker runs continuously and does not stop even when the ice bin is full.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked or failed ice-full sensor, Disconnected sensor wiring, Faulty control board ignoring sensor input
How to Fix / Troubleshooting
Safety first: Unplug the Klarstein ice maker before working near the sensor or bin.
- Clean sensor: If equipped with an infrared sensor, clean both sides of the sensor windows with a soft cloth.
- Check bin position: Ensure the ice basket is correctly installed and not bypassing the sensor beam.
- Inspect wiring: Access the sensor module and verify that its connector is firmly attached to the harness and PCB.
- Test sensor (advanced): With a multimeter or by entering diagnostic mode (if available), verify that the sensor output changes when blocked/unblocked.
If the sensor is working but the unit still does not stop, the main control PCB may need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Ice Full Sensor Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements