Display shows 'ADD WATER' or water droplet icon; unit beeps and stops making ice.

Safety: Turn the unit off and unplug before removing the reservoir or covers.

Steps:

• Refill reservoir: Fill the water tank to the indicated MAX line with clean, cold water. Do not overfill.
• Reset the unit: Plug back in, power on, and press the START/STOP button to resume operation.
• Check float movement: If the message appears even with a full tank, open the lid and locate the float. Move it gently up and down to ensure it is not stuck.
• Clean sensor area: Empty the tank and clean the float and sensor area with a mild vinegar solution to remove mineral deposits. Rinse thoroughly.
• Inspect wiring (if accessible): For models with an electronic level sensor, check that the sensor connector is firmly attached to the main PCB.
• Replace sensor if needed: If the warning persists despite correct water level and cleaning, the water level sensor/float switch may need replacement.